frunumber
Junior Member | Редактировать | Профиль | Сообщение | ICQ | Цитировать | Сообщить модератору
igcomp
Цитата:
Хм. А это? -
Звуковые сигналы
Число сигналов Проблема Решение
1-1-3 Real-time clock write/read failure
1-1-4 ROM BIOS checksum failure
1-2-1 Programmable Interval Timer failure
1-2-2 DMA initialization failure
1-2-3 DMA page register write/read failure
1-3-1 RAM refreash verification failure
1-3-3 1st 64 KB RAM chip or data line failure multi-bit
1-3-4 1st 64 KB RAM odd/even logic failure
1-4-1 1st 64 KB RAM address line failure
1-4-2 1st 64 KB RAM parity test in progress or failure
2-1-1 Bit 0 1st 64 KB RAM failure
2-1-2 Bit 1 1st 64 KB RAM failure
2-1-3 Bit 2 1st 64 KB RAM failure
2-1-4 Bit 3 1st 64 KB RAM failure
2-2-1 Bit 4 1st 64 KB RAM failure
2-2-2 Bit 5 1st 64 KB RAM failure
2-2-3 Bit 6 1st 64 KB RAM failure
2-3-4 Bit 7 1st 64 KB RAM failure
2-3-1 Bit 8 1st 64 KB RAM failure
2-3-2 Bit 9 1st 64 KB RAM failure
2-3-3 Bit A 1st 64 KB RAM failure
2-2-4 Bit B 1st 64 KB RAM failure
2-4-1 Bit C 1st 64 KB RAM failure
2-4-2 Bit D 1st 64 KB RAM failure
2-4-3 Bit E 1st 64 KB RAM failure
2-4-4 Bit F 1st 64 KB RAM failure
3-1-1 Slave DMA register failure
3-1-2 Master DMA register failure
3-1-3 Master interrupt mask register failure
3-1-4 Slave interrupt mask register failure
3-2-4 Keyboard controller test failure
3-3-4 Screen memory test failure
3-4-1 Screen initialization failure
3-4-2 Screen retrace test failure
Добавлено
Миль пардон.Це для Феникса :)))
Добавлено
Испавимся :)
AMIBIOS Beep Codes
Except for beep code #8, these codes are always fatal.
1 beep Refresh failure
2 beeps Parity error
3 beeps Base 64K memory failure
4 beeps Timer not operational
5 beeps Processor error
6 beeps 8042 - gate A20 failure
7 beeps Processor exception interrupt error
8 beeps Display memory read/write failure
9 beeps ROM checksum error
10 beeps CMOS shutdown register read/write error
11 beeps Cache memory bad
For 1 beep, 2 beeps, or 3 beeps try reseating the memory first. If the error still occurs, replace the
memory with known good chips.
For 4 beeps, 5 beeps, 7 beeps, or 10 beeps the system board must be sent in for repair.
For 6 beeps try reseating the keyboard controller chip. If the error still occurs, replace the keyboard chip.
If the error persists, check parts of the system relating to the keyboard, e.g. try another keyboard, check
to see if the system has a keyboard fuse.
8 beeps indicate a memory error on the video adapter. Replace the video card or the memory on the
video card.
9 beeps indicate faulty BIOS chip(s). It is not likely that this error can be corrected by reseating the
chips. Consult the motherboard supplier or an AMI product distributor for replacement part(s).
If no beeps are heard and no display is on the screen, The first thing to check is the power supply.
Connect an LED to the POWER LED connection on the motherboard. If this LED lights and the drive(s)
spin up then the power supply will usually be good.
Next, inspect the motherboard for loose components. A loose or missing CPU, BIOS chip, Crystal
Oscillator, or Chipset chip will cause the motherboard not to function.
Next, eliminate the possibility of interference by a bad or improperly set up I/O card by removing all card
except the video adapter. The system should at least power up and wait for a drive time-out. Insert the
cards back into the system one at a time until the problem happens again. When the system does
nothing, the problem will be with the last expansion card that was put in.
If the above suggestions fail to cause any change in the disfunction of the system, the motherboard
must be returned for repair.
|
Всего записей: 40 | Зарегистр. 07-10-2002 | Отправлено: 16:43 09-10-2002 | Исправлено: frunumber, 16:59 09-10-2002 |
|
