Перейти из форума на сайт.

НовостиФайловые архивы
ПоискАктивные темыТоп лист
ПравилаКто в on-line?
Вход Забыли пароль? Первый раз на этом сайте? Регистрация
Компьютерный форум Ru.Board » Hardware » Драйверы и прошивки BIOS » Восстановление роутера (TP-Link) через Serial

Модерирует : Akam1, Dr_StandBy, vertex4

 Версия для печати • ПодписатьсяДобавить в закладки
На первую страницук этому сообщениюк последнему сообщению

Открыть новую тему     Написать ответ в эту тему

westwild_007



Member
Редактировать | Профиль | Сообщение | Цитировать | Сообщить модератору
C▒H▒▒▒▒с1.1.4 (Jul 26 2010 - 16:19:37)
 
AP99 (ar7241 - Virian) U-boot
DRAM:
sri
ar7240_ddr_initial_config(133): virian ddr1 init
▒▒▒$▒A▒VALUE 1 = 0xf, 2 = 0x10 [0x0: 0x1f]
32 MB
Z▒▒▒▒▒0x100000ff
sector count = 64
Flash:  4 MB
U▒▒▒default environment
 
RK▒▒ɥ▒▒5
        Out:   serial
Err:   serial
▒▒▒   ag7240_enet_initialize...
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
UK▒▒▒▒MDC CFG Value ==> 4
: cfg1 0xf cfg2 0x7014
Y
 ▒▒▒҂▒Һ2▒09:0b:ad
Y
 ▒▒5
    Virian MDC CFG Value ==> 4
: cfg1 0xf cfg2 0x7214
Y+▒▒▒҂▒Һ2▒09:0b:ad
ATHRS26: resetting s26
PJ5%▒▒▒▒6 reset done
Y+▒▒5
     eth0, eth1
Autobooting in 1 seconds
▒$▒▒ѥ▒▒▒image at 9f020000 ...
   Uncompressing Kernel Image ... j▒H▒HhE▒▒ѥ▒▒▒kernel ...
 
Linux version 2.6.37.1 (pavel@calculate) (gcc version 4.5.2 (Linaro GCC 4.5-2011.02-0) ) #7 Sat Mar 12 16:29:04 EET 2011
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR7241 rev 1, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
 memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00002000
▒W▒▒▒1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line:  board=TL-WR741ND rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
%▒▒▒▒▒instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
SY[K▒▒ 29484k/32768k available (1922k kernel code, 3284k reserved, 377k data, 168k init, 0k highmem)
SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:56
Calibrating delay loop... &▒▒I▒▒▒▒5%AM▒(lpj=1331200)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
▒Q▒ Registered protocol family 16
SR5▒j▒▒▒▒▒▒▒is TP-LINK TL-WR741ND
▒▒Vkѕɥ▒▒▒PCI controller with io_map_base unset
&#9618;&#9618;K&#597;&#9618;ѕ&#9618;slab <bio-0> at 0
&#9618;&#9618;&#9618;0000:00:00.0: fixup device configuration
&#9618;&#9618;&#9618;0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1000ffff 64bit]
pci 0000:00:00.0: BAR 0: set to [mem 0x10000000-0x1000ffff 64bit] (PCI address [0x10000000-0x1000ffff])
PCI: mapping irq 48 to pin1@0000:00:00.0
&#9618;W&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;to clocksource MIPS
&#9618;Q&#9618; Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
&#9618;&#1349;&#865;&#9618;&#9618;&#9618; version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[&#9618;V&#9618;+
     B&#9618;&#833;been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
P&#9618;&#637;&#833;AR71xx SPI Controller driver version 0.2.4
[&#9618;&#9618;0 spi0.0: found s25sl032a, expected m25p80
m25p80 spi0.0: s25sl032a (4096 Kbytes)
&#9618;V&#589;&#9618;&#9618;&#9618;&#9618;&#9618;for RedBoot partition table in spi0.0 at offset 0x3e0000
&#9618;V&#589;&#9618;&#9618;&#9618;&#9618;&#9618;for RedBoot partition table in spi0.0 at offset 0x3f0000
&#9618;
 &#9618;&#9618;&#9618;    &#9618;&#9618;сpartition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000020000 : "u-boot"
&#9618;&#9618;00000020000-0x000000160000 : "kernel"
&#9618;&#9618;00000160000-0x0000003f0000 : "rootfs"
[&#9618;&#9618;&#9618;&#9618;&#1125;&#1125;&#9618;&#9618;&#9618;"rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=3C0000, len=30000
0x0000003c0000-0x0000003f0000 : "rootfs_data"
&#9618;&#9618;000003f0000-0x000000400000 : "art"
&#9618;&#9618;00000020000-0x0000003f0000 : "firmware"
X&#9618;S&#9618;&#9618;}&#9618;&#9618;&#9618;&#9618;&#9618; probed
Y
 &#9618;
  &#1121;&#9618;&#637;&#833;AG71xx at 0xba000000, irq 5
Y
 &#9618;2&#9618;&#1401;&#9618;&#9618;an AR7240 built-in switch
Y+&#9618;
   &#1121;&#9618;&#637;&#833;AG71xx at 0xb9000000, irq 4
P&#9618;&#637;&#833;AR71xx hardware watchdog driver version 0.1.0
&#9618;A&#9618;westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
&#9618;&#1317;j&#9618;&#1401;ѕ&#9618;&#9618;root (squashfs filesystem) readonly on device 31:2.
&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;unused kernel memory: 168k freed
Z
 &#9618;&#9618;&#9618; gpio-buttons as /devices/platform/gpio-buttons/input/input0
&#9618;&#9618;&#9618;
   B&#9618;&#9618;&#9618;&#1373;&#9618;driver version 0.4.1
Y
 &#9618;b&#9618;&#9618;&#9618;&#9618;up (1000Mbps/Full duplex)
K&#9618;&#597;&#9618;&#9618;&#9618;с-
%&#9618;&#9618;&#833;the [f] key and hit [enter] to enter failsafe mode
K&#9618;&#9618;&#9618;&#1393;&#9618;&#577;preinit -
-&#9618;&#9618;&#9618;: Too few erase blocks (3)
&#9618;W&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;&#9618;to jffs2
[Z+&#9618;e&#9618;&#9618; using base directory: /
mini_fo: using storage directory: /overlay
KJ&#9618;&#9618;с-
Y
 &#9618;b&#9618;&#9618;&#9618;&#9618;down
C!&#341;&#9618;&#853;&#9618;press Enter to activate this console. [Z+&#9618;e&#9618;&#9618; build_sto_structure: failed to create storage dir [1].
mini_fo: get_neg_sto_dentry: ERROR building sto structure.
mini_fo: create_sto_file: ERROR getting neg. sto dentry.
5&#9618;C!&#341;&#9618;&#853;&#9618;press Enter to activate this console.

Всего записей: 224 | Зарегистр. 28-05-2008 | Отправлено: 15:26 26-10-2013 | Исправлено: westwild_007, 21:28 26-10-2013
Открыть новую тему     Написать ответ в эту тему

На первую страницук этому сообщениюк последнему сообщению

Компьютерный форум Ru.Board » Hardware » Драйверы и прошивки BIOS » Восстановление роутера (TP-Link) через Serial


Реклама на форуме Ru.Board.

Powered by Ikonboard "v2.1.7b" © 2000 Ikonboard.com
Modified by Ru.B0ard
© Ru.B0ard 2000-2024

BitCoin: 1NGG1chHtUvrtEqjeerQCKDMUi6S6CG4iC

Рейтинг.ru