Smyg1
Gold Member | Редактировать | Профиль | Сообщение | ICQ | Цитировать | Сообщить модератору
Цитата: wlo
и в uart ничего интересного не пишет? |
eCLI не может String section загрузить на этой плате даже с прошивкой 5.8.2
Цитата: [12-28-18 12:42:02.734] eCLI_SerialInit:103 String section 0x00000000 size 0 uartRxThreadFun:488 Started
[12-28-18 12:42:02.734]<< Send Wake up, Wait 250 ms >>
[12-28-18 12:42:03.281] << Send Wake up, Wait 250 ms >>
[12-28-18 12:42:03.281]<< Awake >>
[12-28-18 12:42:03.531]Failed: UART Time Out, status = 0x1
[12-28-18 12:42:05.578] Failed to load string, reload
[12-28-18 12:42:05.578]Failed: UART Time Out, status = 0x1
[12-28-18 12:42:07.593] Failed to load string, reload
[12-28-18 12:42:07.593]Failed: UART Time Out, status = 0x1
[12-28-18 12:42:09.625] Retried 3 times. Failed to load string sections! Please check drive and UART cable!
[12-28-18 12:42:09.625] |
если вместо CL залить FM то после передерга питания стартует и работает в MFB...
Цитата: [ROM] PORRST
[ROM] Rev: 402 CID: 200026BB BID: 625280
[ROM] Try BCH[1]: CP=33 EC=54 EP=485
[ROM] Try BCH[2]: CP=29 EC=48 EP=485
[ROM] Try BCH[3]: CP=36 EC=59 EP=485
[ROM] Try BCH[4]: CP=39 EC=64 EP=485
[ROM] Load CRP
[CRP] Switching to Sync...
[ROM] Load FWR
<MFB> FlashQuadCtrlVerifyFlash: Lane 0 CE 0 Bus 0
<MFB> FlashQuadCtrlVerifyFlash: Lane 0 CE 0 Bus 1
<MFB> FlashQuadCtrlVerifyFlash: Lane 1 CE 0 Bus 0
<MFB> FlashQuadCtrlVerifyFlash: Lane 1 CE 0 Bus 1
<MFB> FlashQuadCtrlVerifyFlash: Lane 2 CE 0 Bus 0
<MFB> FlashQuadCtrlVerifyFlash: Lane 2 CE 0 Bus 1
<MFB> FlashQuadCtrlVerifyFlash: Lane 3 CE 0 Bus 0
<MFB> FlashQuadCtrlVerifyFlash: Lane 3 CE 0 Bus 1
<MFB> ********************************
<MFB> ***** Basic FLASH tests OK *****
<MFB> ********************************
<MFB> RootFileOpen(): not allowed yet [fid:21, mode:00000001, flags:00000003].
<MFB> ---> Sector size 0 bytes L-Page size 4096 bytes <---
SataPowerOnReset, Security: -> unlockedSecurity: Disabled
H/w Decode enabled
<MFB> ---> Sector size 0 bytes L-Page size 4096 bytes <---
<MFB>
*** MFB 582 Jul 3 2014 04:25:12 B:FW_PPRO_5_6_1_20140326_836378:FW_PPRO_5_8_2_Release-906190
*** Build Options : cfg/cfg_MLC_Micron_128Gb_33bit_FT16B08UCM1-3B_2Q_1C_1D -noenterprise -asic -subdir SF-2281_Board -pdump -elog -ecli -release -ecliLevel0 -div2 -sysclk300 -nochipsocket -mfb -noecli -suffix PP_R02795_s512 ANYHOST
*** Chip RevId from HW: B03 (ID=625280), FW Targeted For: B02 ASIC ***
*** SysClk : 300 MHz
*** Packer : 500 MHz
*** Flash : 830 MHz
*** FlaDiv : 2
*** GP1011 : 2 (0=Async ONFI, 1=Toggle, 2=ONFI, 3=Async Toggle)
<MFB>
*** GPIO0 : 0
<MFB> Scap charge wait
<MFB> Scap charge done
<MFB User> libSfStartC enter cfg:3fff4d98
<MFB> RootFileOpen(): not allowed yet [fid:8, mode:00000001, flags:00000003].
<MFB User> UserMain: CheckRetiredBlkCntAtClearSmart failed. |
Цитата: SandForce FW:582ABBM0 SN:1 WWN:500232D000000001
Logical: Cyls 16383, Heads 16, Sectors 63, LBA 250000000, 128Gb
Security Erase Time: 0h 2min, Enhanced: 0h 2min
SMART: Enabled
HPA: Not Supported
LBA48: Supported
AAM: Not Supported
APM: Not Supported
DLMcode: Supported
Write Cache: Enabled
Security: Not Supported
SCT: , AC5
Drive Panic Log Directory Listing:
# RevTran Sync UnLvl HdrSize DataSize Epa CRC Valid
-----------------------------------------------------------------------
0 FBFF9 62A28E64 0 D3C 2D1DE0 80002 1 1
1 114F68 F7B33237 0 D3C 2D1DE0 20080002 1 0
2 110497 FF357B99 0 D3C 2D1DE0 A0002 1 1
3 110497 FF357B99 0 D3C 2D1DE0 200A0002 1 1
Panic Dump Header
-----------------
Accumulative Time..: 0 hours 0 minutes 6 seconds
Total Up Time......: 0 hours 0 minutes 6 seconds |
33491 поведение такое же...
даже смарт отдает:
Цитата: KINGSTON SHFS37A120G FW:604ABBF0 SN:50026B725605E286 WWN:50026B725605E286
Logical: Cyls 16383, Heads 16, Sectors 63, LBA 250000000, 128Gb
Security Erase Time: 0h 2min, Enhanced: 0h 2min
S.M.A.R.T. status - GOOD
Wear Distribution Data
---------------------------------
Table Entries...................: 256
Count min.......................: 0
Count max.......................: 0
Count 0 of blocks (at wear min).: 1014
Count 2 of blocks...............: 9
Manufacturing Defect List Count.: 16
Grown Defect List Count.........: 1 |
попробовал в качестве CL использовать VIC из апдейтилки:
Kingston SSD Manager with Firmware Update 1.0.1.8\firmware\60A\33205_fw.vic
поведение такое же...
попробовал процессить, а потом залить апдейт 60A\33205_fw.vic
поведение такое же...
|
Всего записей: 5387 | Зарегистр. 03-10-2006 | Отправлено: 12:53 28-12-2018 | Исправлено: Smyg1, 17:22 28-12-2018 |
|
