maked0nski
Newbie | Редактировать | Профиль | Сообщение | Цитировать | Сообщить модератору Всем привет. Есть TL-WR740N v/4.21 вроде с залитой левой прошивкой. TX на CPU сопля проброшена. tpl не могу ввести. ( прошивал уже не 1 десяток. таких проблем не было) лог: U-Boot 1.1.4 (Jan 11 2013 - 14:46:35) AP121-2MB (ar9330) U-boot DRAM: 32 MB led turning on for 1s... id read 0x100000ff flash size 4194304, sector count = 64 Flash: 4 MB Using default environment In: serial Out: serial Err: serial Net: ag7240_enet_initialize... No valid address in Flash. Using fixed address No valid address in Flash. Using fixed address : cfg1 0x5 cfg2 0x7114 eth0: 00:03:7f:09:0b:ad ag7240_phy_setup eth0 up : cfg1 0xf cfg2 0x7214 eth1: 00:03:7f:09:0b:ad athrs26_reg_init_lan ATHRS26: resetting s26 ATHRS26: s26 reset done ag7240_phy_setup eth1 up eth0, eth1 Autobooting in 1 seconds ## Booting image at 9f020000 ... Uncompressing Kernel Image ... OK Starting kernel ... Booting AR9330(Hornet)... Linux version 2.6.31--LSDK-9.2.0.312 (root@localhost.localdomain) (gcc version 4 .3.3 (GCC) ) #3 Thu Dec 13 11:06:48 CST 2012 flash_size passed from bootloader = 4 CPU revision is: 00019374 (MIPS 24Kc) Determined physical RAM map: memory: 02000000 @ 00000000 (usable) User-defined physical RAM map: memory: 02000000 @ 00000000 (usable) Zone PFN ranges: Normal 0x00000000 -> 0x00002000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00002000 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: console=ttyS0,115200 root=31:02 rootfstype=squashfs init=/s bin/init mtdparts=ar7240-nor0:128k(u-boot),1024k(kernel),2816(rootfs),64k(config ),64k(ART) mem=32M PID hash table entries: 128 (order: 7, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing ErrCtl register=00000000 Readback ErrCtl register=00000000 Memory: 29864k/32768k available (1892k kernel code, 2904k reserved, 521k data, 1 16k init, 0k highmem) Hierarchical RCU implementation. NR_IRQS:128 plat_time_init: plat time init done Calibrating delay loop... 266.24 BogoMIPS (lpj=532480) Mount-cache hash table entries: 512 NET: Registered protocol family 16 ===== ar7240_platform_init: 0 Whoops! This kernel is for product wr741 v4.0! bio: create slab <bio-0> at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) net_link: create socket ok. TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered NET: Registered protocol family 1 AR7240 GPIOC major 0 squashfs: version 4.0 (2009/01/31) Phillip Lougher NTFS driver 2.1.29 [Flags: R/O]. msgmni has been set to 58 alg: No test for lzma (lzma-generic) alg: No test for stdrng (krng) io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled ttyS0: detected caps 00000000 should be 00000100 serial8250.0: ttyS0 at MMIO 0xb8020000 (irq = 19) is a 16550A console [ttyS0] enabled PPP generic driver version 2.4.2 NET: Registered protocol family 24 cmdlinepart partition parsing not available set partition boot set partition kernel set partition rootfs set partition config set partition art set partition Ъ Searching for RedBoot partition table 5 RedBoot partitions found on MTD device ar7240-nor0 Creating 5 MTD partitions on "ar7240-nor0": 0x000000000000-0x000000020000 : "boot" 0x000000020000-0x000000120000 : "kernel" 0x000000120000-0x0000003e0000 : "rootfs" 0x0000003e0000-0x0000003f0000 : "config" 0x0000003f0000-0x000000400000 : "art" ->Oops: flash id 0x1c3016 . ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver Port Status 1c000004 ar7240-ehci ar7240-ehci.0: ATH EHCI ar7240-ehci ar7240-ehci.0: new USB bus registered, assigned bus number 1 ehci_reset Intialize USB CONTROLLER in host mode: 3 ehci_reset Port Status 1c000000 ar7240-ehci ar7240-ehci.0: irq 3, io mem 0x1b000000 ehci_reset Intialize USB CONTROLLER in host mode: 3 ehci_reset Port Status 1c000000 ar7240-ehci ar7240-ehci.0: USB 2.0 started, EHCI 1.00 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected TCP cubic registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> ar7240wdt_init: Registering WDT success VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing unused kernel memory: 116k freed init started: BusyBox v1.01 (2012.09.25-12:47+0000) multi-call binary This Board use 2.6.31 xt_time: kernel timezone is -0000 nf_conntrack version 0.5.0 (512 buckets, 5120 max) ip_tables: (C) 2000-2006 Netfilter Core Team insmod: cannot open module `/lib/modules/2.6.31/kernel/iptable_raw.ko': No such file or directory insmod: cannot open module `/lib/modules/2.6.31/kernel/flashid.ko': No such file or directory PPPoL2TP kernel driver, V1.0 PPTP driver version 0.8.3 insmod: cannot open module `/lib/modules/2.6.31/kernel/harmony.ko': No such file or directory unlzma/peek_old_byte: position 9303 out of range unlzma/peek_old_byte: position 2202704 out of range SQUASHFS error: crypto_decompress_update returned -25755, data probably corrupt SQUASHFS error: squashfs_read_data failed to read block 0x113474 SQUASHFS error: Unable to read data cache entry [113474] ......... SQUASHFS error: Unable to read page, block 113474, size 8118 (none) mips #3 Thu Dec 13 11:06:48 CST 2012 (none) (none) login: помогите поднять зверька плз. |