Asinus
Newbie | Редактировать | Профиль | Сообщение | Цитировать | Сообщить модератору Рад сообщить, что появилась информация о самостоятельной починки колеса. "I have had the same problem, sudenly dead for no reason. I did not have warranty and then I tried to fix it myself. The command dial has an tiny plastic extension hexagonal 1/16 inch that connects fit to an electronic device, this extension rod is so small and it is broken and there is nothing happen when turning it. I wrote to fuji and they refused to sell it to me for reason not being an accredited technictien. You have to send your s9000 to you local Fuji center, I think that they will repalace the command dial for free. My case, I find out a same size alen key, cut it, drill in inner side of the dial and ciment it with epoxy, now it works normaly. It is a job of an jeweller. This is the big weakness of this camera." (человек заменил шестигранную ось колеса путем вклейки обрезка ключа Аллена такого-же размера) "OK, I try my best. First he removed batteries and the card (may not be necessary), Than unscrewed the left top part. This comes off in one piece, just be careful with the thin data cable that is attached to the main body. The knob itself has a upper part with the large rod, and the lower part, which has 4 small rods. The small rods fit into the holes of the metal disk, he glued the two parts of the knob together with some distance between them (I'm not shure this was proper, but it clicks again). On the backside of the left-top piece there are two more screws, then you have access to the knob lower part and the electronic parts. He used an engeneers' drill to make a small hole in the center of the knob, and also made the hole of potentiometers plate a bit larger (this is where the bigger rod goes originally. Then, he screwed in a thin metal screw from below, it was a bit thicker than to original rod (similar length without the head), the screw's head had remained under the potentiometer (apparently there's some space for that). Finally, he glued together the knob and the top of the rod-screw, replaced the other screws, data cable, assambled the top. That was all I could see above his shoulders. I think the main problem is finding the right size screw for the repair (it took him some minutes). The one inserted into my knob was like a bolt, almost rectangular with a sharp tiny top." (подобная предыдущей операция) |